Watch the video tutorial here.

Step 1
Snap the heart rate transmitter to the electrode pocket on the belt and close the pocket.

Step 2
Standing on the left side of the horse, place the belt over the horse’s withers and secure the slide closure. Adjust the tightness of the belt to ensure that it is snug against the horse’s barrel.

Step 3
Rotate the belt so the transmitter is about two-thirds down the horse’s barrel.
Note: Most horses will be comfortable with the slide closure below the elbow, but you may need to adjust its placement based on the horse’s conformation.


Step 4
Flip over belt, apply gel to both top and bottom electrodes, and flip back into place.

Step 5
Tack up the horse as you normally would, ensuring that the sensor pocket is in front of the girth, and recheck belt tightness.


Correct placement with heart rate monitor in front of girth.

Incorrect placement with the heart rate monitor behind the girth.

Step 6
Open the KER ClockIt Sport app and start a new session. Swipe the map to the left to confirm the heart rate signal.

Start your session and enjoy your ride!
After your ride, remove transmitter from the belt, rinse the belt under running water, and hang to dry.